6/6/2023 0 Comments Civil 3d geolocation![]() ![]() Zoom in to see that the point is in the same position as what it was in Civil 3D. Place the point at the location of the Northing and Easting. When locating, use S/N and S/E to indicate the latitude and longitude. In AutoCAD Vanilla, first draw a line to the Northing and Easting in the World Coordinate system. Note Labels were created to indicate the Northing and Easting and Latitude and Longitude. ![]() In the case below, true north is directly up, so one does not have to worry about that. Northing and Easting in the coordinate system of interest.One must know three items of information for a point that is used to define the map overlay and coordinate system. Dropping the pin in the wrong latitude and longitude or in the wrong position leaves one with a situation where the image may display correctly, but the Nothing and Easting is incorrect. These two need to be aligned with each other to get a consistent result. Bing imagery is referenced as per the latitude and longitude, whereas the point is indicated with reference the UCS. Most users are of the opinion that all one must do is drop a pin, but this is not so. ![]() When bringing Geo referenced information into AutoCAD (not Civil 3D or AutoCAD MAP), it is necessary to set the coordinate system. ![]()
0 Comments
Leave a Reply. |